Paint Matching & Respray in Midland, TX
Factory paint matching for partial panel blends and full vehicle respray. Color is pulled from the manufacturer code, adjusted for sun fade on adjacent panels, and verified on a spray-out card before any panel is sprayed. Same booth, same painter, every job.
Match a Panel. Or Respray the Whole Vehicle.
Paint work falls into two scopes. A partial match blended into existing paint, or a full vehicle respray. The right answer depends on the condition of the rest of the paint and what the vehicle is being used for.
Partial Panel or Single Panel
- Manufacturer paint code pulled from the vehicle VIN sticker
- Spray-out card mixed and verified before any panel is sprayed
- Adjustment for sun fade and age on adjacent panels
- Blend into adjacent panels to hide the repair edge
- Base coat and clear coat applied to factory thickness
- Color sanded and buffed to match factory finish
- Color match verified under shop and natural light
Complete Color Change or Refresh
- Original paint sanded or stripped to bare metal where needed
- Body prep, primer, and seam sealer to factory standard
- Base coat, clear coat, and pearl steps for tri-coat colors
- Color change quoted with door jambs, engine bay, and trunk included
- Cost scales with prep scope and color choice
- Restoration projects matched to era-correct finish
- Full booth time, no cuts on cure or sand time
Four Steps. Same Every Job.
Paint that disappears into the rest of the vehicle is hard. It takes the same sequence every time. Skip a step and the match falls apart in daylight or after one wash cycle.
-
01
Pull the Color Code
Manufacturer paint code pulled from the VIN sticker or door jamb. Tri-coat and pearl codes include the additional clear and pearl identifiers.
-
02
Mix & Test on Card
Color mixed to the code. Spray-out card sprayed and dried. Compared against adjacent panels under shop and natural light before any panel is touched.
-
03
Prep & Booth
Panel sanded, sealed, and masked. Base coat and clear coat applied in our climate-controlled booth. Multiple flash coats. Cured to spec, not shortcut.
-
04
Color Sand & Buff
Wet sand to flatten the clear, buff to factory gloss. Body line and panel gap check. Color match verified across panels before delivery.
One Painter. One Booth.
Paint match consistency comes from doing the work in the same conditions every time. Same booth, same painter, same color-match process. We do not subcontract paint work and we do not run paint outside the booth.
- Color Code Manufacturer paint code from your vehicle. Spray-out card always verified before any panel is sprayed.
- In-House Booth Climate-controlled paint booth on site. Every panel painted in the same conditions for consistent finish.
- Tri-Coat & Pearl Tri-coat and pearl colors fully supported. Additional clear and pearl steps applied per manufacturer specification.
- Lifetime Guarantee Paint workmanship guaranteed against premature failure for the life of your ownership. Signed by Chris, in writing.
Common Questions
Will the paint match exactly on a single-panel repair?
Can you do a full color change on my vehicle?
How long does a full vehicle respray take?
Do you paint commercial vehicles and fleet trucks?
Do you guarantee your paint work?
Single Panel or Full Respray?
Bring it in. We will pull the color code, mix on a spray-out card, and quote the work honestly. No subcontracted paint, no shortcuts on prep.